Artopex e-Motion - Restore Factory Settings (11 r)

1 800 378-0189
sac@artopex.com
9
Settings (cont’d) & Warranty
Timer - 9St
The timer makes it possible to define the period of time for the same surface position. This is to stimulate
the change from sitting to standing position.
Activate keypad by pressing any button. Press «M» button for 3 seconds, screen will display S--,
release the «M» button and press the «up» arrow until code 9St appears. Press «M» button to enter;
screen will display 0.0H (hours.minutes). Press the UP/DOWN buttons to adjust timer with 0.5 H (30
minutes) increments, and press the «M» button to activate timer. Note: When the timer expires, the
keypad will emit a «beep» sound and reposition the surface to the height it was before setting the timer.
Bounce Travel - 10H
The Bounce Travel is the distance the surface moves back when it hits an obstacle while raising or
lowering.
Activate keypad by pressing any button. Press «M» button for 3 seconds, screen will display S--, then
release the «M» button and press the «up» arrow until code 10H appears. Press «M» button to enter,
screen will display the current bounce travel. Using the UP/DOWN buttons, select bounce travel and
press the «M» button to confirm selection.
Restore Factory Settings - 11r
Warning: this mode can erase all the parameters that have been previously adjusted for your program.
Activate keypad by pressing any button. Press «M» button for 3 seconds, screen will display S--, then
release the «M» button and press the «up» arrow until code 11r appears. Press «M» button to enter,
screen will display Frt (flashing). Press «M» button to confirm & exit. Screen will display rES, execute
the Reset Procedure (page 3) to finilize Factory Settings Restoration.