Arturia Prophet V - Page 105

ARTURIA – PROPHET V - MANUAL
105
Wave forms of oscillator C and D
Editing the FILTER and the AMPLIFIER:
To edit the filter envelop, click on the “EDIT” button found in the graphic representation of the
envelope.
 Point “0” must be set on the maximum initial level (value = 99) to have the maximum
value at the beginning of the note.
 Set Point “1” at a LEVEL of 99 and a RATE of 0. The attack of this note will be really short
on the filter.
 Set point “2” at a LEVEL around 48 and a RATE relatively short (144). The cutoff
frequency falls rapidly toward the intermediate point.
 Set point “3” with a LEVEL a bit lower (about 30) and a RATE a bit longer (479). The
cutoff frequency falls again towards the intermediate point before coming to the
“SUSTAIN” phase.
 Finally, set point “4” with a level slightly higher than before (63) and a RATE a bit longer
(600). The cutoff frequency will increase slowly at the release of the note.
Settings of the Filter envelope
Now we’ll set the amplifier envelope:
 Point “0” must be set on the maximum initial level (value = 99) to have the maximum
value at the beginning of the note.
 Set Point “1” at a LEVEL of 99 and a RATE of 0. The attack of this note will be really short
on the filter.
 Make the same adjustments to point “2” as you did to point “1”.
 The settings of point “3” will define both the Decay phase and the sustain: set the LEVEL
to around 60 and the fall time to about 1500 ms (which is relatively long).