Arturia Prophet V - Page 53

ARTURIA – PROPHET V - MANUAL
53
• Frequency of oscillator B (« FREQ B »)
• Squared width of oscillator A (« PW A »)
• Squared width of oscillator B (« PW B »)
• Frequency of cut-off filter (« FILTER »)
Destination Connection
5.1.8 POLY MOD
This section offers the necessary connection for high frequency modulations (FM).
These modulations are made by polyphonically played modules: oscillator B and the envelope of
the filter.
With “Poly Mod” you can modulate the frequency and the pulse width of oscillator A as well as
the cut-off frequency of the filter. This allows you to create metallic sounds, similar to bell
sounds, or very particular special effects (notably by modulating the cut-off frequency of
oscillator B).
Notice! If you use oscillator B as a modulation source, you can apply a modulation in which the speed will be
proportional to the note played on the keyboard. This gives you some interesting effects when oscillator B will be used
in the lower frequencies (LO FREQ).
Source Amount : setting for the modulation rate of:
• The filter envelope(« FILT ENV »)
• Oscillator B (« OSC B»)
DESTINATION : selection buttons for modulation destinations:
• Frequency of oscillator A (« FREQ A »)
• Squared width of oscillator A (« PW A »)
• Cut-off filter frequency (« FILTER »)
The FM polyphonic modulation section
5.1.9 Section modes for the keyboard
This section allows you to: