Aruba 1 Series User Manual

Analyzer Models with Fiber Management Port
This section applies to models: AI-ANA-1050-AN | AI-ANA-1050-CN | AI-ANA-1550-AN | AI-ANA-1550-CN
Racking the Analyzer Appliance
Use the following steps to install Analyzer:
1. Locate the Rails
2. Attach Outer Rails and Install Chassis
Locate the Rails
1. The inner rail is pre-installed on the chassis.
2. Outer rail to be installed on the rack.
Figure 6 Locate Rails
Attach Outer Rails and Install Chassis
1. Attach the outer rail to rack.
2. Align Analyzer's inner rails with the outer rails and slide unit until the lock clicks.
3. Install all other nodes similarly.
Figure 7 Attach Outer Rails and Install Chassis
IntroSpect Analyzer 1XXX Series | Quick Start Guide 5

Aruba 1 Series Specifications

General

Brand	Aruba
Model	1 Series
Category	Measuring Instruments
Language	English