8.Timing Setting
▶ Press <1>&<3> at the same time, the handset displays 0.0h during the initial
setting , then press <↑>or<↓> to adjust the timing, with 0.5 hours as a change,
and automatically exit after 2 seconds. At this time, a decimal point will flash after
the handset is turned off, indicating that there is a timing running. When the timing
is reached, the buzzer will beep 5 times and the handset will wake up automatically.
5.Upper and Lower Limit Settings
▶ The system supports the height limit of the desk. The operation method is,
press and hold the <↑>&<↓> at the same time for 5 seconds at the corresponding
height until hear the buzzer, indicating the limit position is stored successfully.
When the desk is in the upper half of the stroke, the limit is the highest position.
When in the lower half of the table stroke, the limit is the lowest position.
▶ Cancel height limit
Method 1: Reset the system, the high and low limit will be cancelled.
Method 2: Run the desk to the limit high or low point, press and hold the <↑>&<↓>
for 5 seconds at the same time until hear the buzzer, indicating that the limit
position is canceled successfully.
6.Lock and Unlock
▶ Lock: Press and hold <M>&<↑> together for 5 seconds, when the digital display
shows "Loc", it means the system has been locked, and the desk cannot be raised
or lowered.
▶ Unlock: Press and hold <M>&<↓> together for 5 seconds, when the digital
display shows from "Loc" to normal digital, it means the system has been
unlocked.
7.Reset
▶ When the system is replaced with a new leg, or the parameters need to be
restored to the factory settings, press and hold <↑>&<↓> for 10 seconds at the
same time to hear a long buzzer, and the parameters are restored to the factory
settings and forced to initialize.
To Next Page
Loading...