11
Regulatory compliance statements
Regulatory Compliance Statements (EU/EFTA only)
This equipment is intended to be used in the whole EU &
EFTA.
This equipment is in compliance with the essential
requirements and other relevant provisions of R&TTE Directive
1999/51/EC. The Declaration of Conformity may be
consulted at:
https://www.ascom-ws.com/doc/
The handset is marked with the label
Regulatory Compliance Statements (USA and Canada
only)
• FCC ID: BXZDH3
• IC: 3724B-DH3
• US: 9FVW4NANDH3
FCC compliance statements
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
