16
Controllers
G12 REMOTE CONTROLLER
Temperature Setting
• To set the desired room
temperature, press the button to
increase or decrease the set
temperature.
• The temperature setting range is
from 16°C to 30°C
• Press both buttons simultaneously
to toggle the temperature setting
between °C and °F
Turbo Mode
• Press the TURBO button to
achieve the required set
temperature in a short time.
ON Timer Setting
• Press the SET button will activate
the on timer function.
• Set the desired on time by pressing
the SET button continuously.
• Press the CLR button to cancel the
off timer setting
Sleep Mode
• Press the button to activate sleep
mode. This function is available
under COOL, HEAT & AUTO
mode.
• When it is activated in COOL
mode, the set temperature will be
increased 0.5°C after 30mins, 1°C
after 1 hour and 2°C after 2 hours.
• When it is activated in HEAT
mode, the set temperature will be
decreased 1°C after 30mins, 2°C
after 1 hour and 3°C after 2 hours.
Personalised Setting
• Press and hold the button for 3s to
initiate personalized setting.
• Set the individual setting e.g.
MODE, SET TEMP or FAN SPEED
and leave for 4s to save
• 2 groups of settings are allowed to
stored in the handset
Fan Speed Selection
• Press the button until the desired
fan speed is achieved.
Operating Mode
• Press the MODE button to select
the type of operating mode.
• For Cooling only unit, the available
modes are: COOL, DRY & FAN.
• For Heatpump unit, the available
modes are: AUTO, COOL, DRY,
FAN & HEAT.
OFF Timer Setting
• Press the SET button will activate
the off timer function.
• Set the desired off time by
pressing the SET button
continuously.
Automatic Air Awing
• Press the SWING button to activate
the automatic air swing function.
• To distribute the air to a specific
direction, press the SWING button
and wait until the louver move to
the desired direction and press the
button once again.
On/Off Button
• Press Once to start the air
conditioner
• Press again to stop the unit
Clock Time Setting
• Press button + or - to increase or
decrease the clock time.
Ionizer / Non-Thermal Plasma
• Press the button to activate the
*Negative Ion / Non-Thermal
Plasma function, which will refresh
the indoor air effectively.
* Depends on specification.
To Next Page
Loading...
Need help?
General
