ascon XE Series - Page 17

15
Manuale XE inglese
239.5
239.5
Active high
(above)
Active low
(below)
Set point ∆W (1)
-300...+300 units
compared to W1
inhibition
W1
∆W
On
Off
Startup
Deviation with startup inhibition
mA
° C
Any interruption in the connections or
any anomaly in the operation of one
of the control loop components, will
cause the output Y2 to be energized
after a few minutes and the whole
front display will be flashing.
The alarm state will stop when the
anomaly causing it stops or
depressing any key for silencing it.
Y1
“Loop-Break-Alarm” LBA (control loop defect/interruption)
inhibition
W1
∆W
On
Off
Startup
With ON-OFF
action "LBA"
feature is not available
!
5 • Y2 - Y3 AUXILIARY OUTPUTS