Need help?Do you have a question about the Asentria Teleboss 850 and is the answer not in the manual?
Lists hardware and information needed for initial setup and operation.
Provides instructions and safety notes for physically installing the unit in a rack.
Details the connection procedures for cables and the power supply.
Specifies the power input types and requirements for the unit.
Explains how to connect to the unit using a serial terminal emulator.
Describes using OmniDiscover for network-based device discovery and configuration.
Guides on configuring network settings via the serial interface menu.
Provides steps to verify network connectivity using the PING command.
Details the configuration steps for setting up the T850 to send SNMP traps.
Provides a fundamental overview of the T850's capabilities and purpose.
Details the boot sequence and LED behavior during startup.
Lists default user accounts and passwords for initial access.
Explains the unit's status display and its key information components.
Introduces the structure and organization of the T850's configuration menu system.
Describes different input methods like string entry, toggle, and option lists.
Configures the parameters for the unit's Ethernet interfaces, including VLANs.
Allows configuration of static routes for fine-tuning outbound network traffic.
Selects between User Profiles or RADIUS for user access control and authentication.
Configures individual user accounts, permissions, and access methods for the unit.
Configures the unit to use a RADIUS server for centralized AAA (Authentication, Authorization, Accounting).
Covers commands for managing scripts, including starting, stopping, and listing.
Provides instructions for upgrading the unit's firmware via FTP client or server methods.
Lists and explains commands for retrieving and setting unit configuration parameters.
Explains the syntax for accessing read-only status information using SK commands.
Details how to establish a pass-through connection to devices attached to serial ports.
Guides on configuring data events to trigger actions based on received data patterns.
Explains how the unit sends SNMP traps for alarm notifications and their formats.
Describes the format and content of email alarm notifications sent by the unit.
Details configuration for contact closure inputs, including enabling and event state actions.
Explains the Generic Server protocol for collecting records from IP-enabled switches.
Details the configuration steps for setting up the ADSL modem, including connection protocols.
Explains how to configure DSL routing and Network Address Translation (NAT).
General| Protocols | SNMP, HTTP, HTTPS, Telnet, SSH |
|---|---|
| Alarm Notifications | Email, SMS, SNMP Traps |
| Mounting | Rack-mountable |
| Weight | 5 lbs |
| Communication Interface | Ethernet |
| Relay Outputs | 4 |
| Humidity Range | 5% to 95% RH, non-condensing |
To Next Page
