8. Program stop
During the charging process, press STOP to stop the charging process
9. Program Complete
When the charging process finishes, an audible sound will be heard.
Charging program
Depending on different battery type, the operation programs are different.
Batt Type Operation Program Description
LiPo
LiHV
Lilon
LiFe
CHARGE This charging mode is for charging LiPo/LiHV/LiFe/Lilon battery in normal mode.
DISCHARGE This mode is for discharging LiPo/LiHV/LiFe/Lilon battery.
STORAGE This program is for charging or discharging lithium battery which will not be
used for a long time.
FAST CHG The charging capacity may be a bit smaller than normal charging, but the
process time will be reduced.
BAL CHARGE This mode is for balancing the voltage of lithium-polymer battery cells while
charging.
NiMH
NiCd
CHARGE The charger will charge NiMH and NiCd batteries using the charge current set
by the user.
AUTO CHG In this program the charger detects the condition of the battery which is con-
nected to the output and automatically charges the battery.
Note: You should set up the upper limit of the charge current to avoid damage
by excessive feeding current. Some batteries of low resistance and capacity can
lead to higher current.
DISCHARGE This mode is for discharging NiMH/NiCd battery.
RE-PEAK In re-peak charge mode, the charger can peak charge the battery once, twice or
three times in a row automatically. This is good for confirming the battery is fully
charged, and for checking how well the battery receives fast charges.
CYCLE 1 to 5 cyclic and continuous process of charge>discharge or discharge>charge is
operable for battery refreshing and balancing to stimulate the battery’s activity.
Pb
NORMAL CHG This mode is for charging Pb battery.
AGM CHG This mode is for charging AGM battery.
COLD CHG This mode is for charging Pb battery in cold days when the temperature is 5°C
to -20°C.
DISCHARGE This mode is for discharging Pb battery.
To Next Page
Loading...
