ASG DTT-5 - Table of Contents

2
TABLE OF CONTENTS PAGE
Introduction 3
Standard Equipment 3
Charging the Battery and Preparing the UNIT for Use 3-4
Operation of the DTT Meter with the Factory Defaults 4-5
Overload Capacity 5
Procedure for Manual Torque Drivers 5-6
Procedure for Power Screwdrivers 6
Instructions for using the Driver Adapter 6-7
Parts and Accessories 8
Calibration 9
Printing and Data output 9
Service and Warranty 9
System Overview 10
Torque Conversion Factors 11
NOTE! The Programming and Calibration Manual contains the password to enter the
calibration menu. To prevent tampering or unauthorized access, separate the Programming
and Calibration Manual store it away from the meter. You may also change the default
password to prevent unauthorized entry into the calibration program. However, if you change
the password and lose it, or forget it, the meter must be returned to ASG to restore the
default password.