HEADSET INSTALLATION:
All Breezer road bikes come with integrated headsets. No headset tool is required. Clean and grease headset cups before
installing bearings.
Do not mix headset components with other headsets. For example, crown races vary from headset to
headset.
REAR DERAILLEUR:
Clean and lightly grease threads prior to installation. Recommended torque for the rear derailleur is 70 in-lbf (8N-m). Do not
exceed maximum torque of 87 in-lbf (10 N-m).
BRAKES:
Recommended torque for road brake calipers is 70 in-lbf (8 N-m). Do not exceed maximum torque of 87 in-lbf (10 N-m).
WATER BOTTLE CAGE:
Recommended torque for the water bottle cage bolt is 35 in-lbf (3.9 N-m). Do not exceed maximum torque of 40 in-lbf (4.5
N-m).
Warning: You should always take extreme precaution to not damage carbon fiber or composite materials, including frame
or other carbon/composite component. Damage may result in loss of structural integrity. This damage may not be visible.
Before each ride and after every crash, you should carefully inspect your bicycle for any dents, gouges, fraying, scratches
through the paint, chipping, bending, or any other signs of damage. It is recommended by Breezer Bikes that you take your bike
to a Breezer dealer for a complete inspection if it shows any of these signs.
WARRANTY:
For complete warranty provisions, please see the owner’s manual or visit your local authorized
Breezer dealer.
57
To Next Page
Loading...