CARBON FRAME GUIDE
Please read the following instructions. If you have any doubt regarding your mechanical ability, visit your local authorized
Breezer dealer. Breezer recommends that the seat post be installed according to recommended torque specification by a qualified
mechanic.
Warning: F
ailure to follow any warning may result in a catastrophic failure of the seat post, resulting in serious injury or
death. This phrase may not be repeated in connection with each warning.
Assembling a complete bicycle is a complicated task. Only a trained and experienced bicycle mechanic should install
components to this frame.
Warning: Bicycle assembly requires training and experience. If you do not have the experience and training as a bicycle
mechanic, DO NOT attempt the assembly of this bike. Failure to follow this warning may result in serious injury or death.
Follow all torque specifications to ensure the best assembly possible and to prevent any damage to the components or frame.
For correct torque specifications as well as recommended loads that the contact points of the frame are capable of accepting,
please refer
to the owner’s manual.
Warning: F
ailure to follow torque specifications will void your warranty. It may also damage the frame, which may not be
visible to the eye. If there is damage to the frame, this can result in loss of structural integrity, which may result in serious
injury or death.
All bicycle components should be compatible with each other (i.e. handlebar, handlebar stem, seat post, saddle, brakes, etc.).
Any doubt regarding compatibility should be addressed with an authorized Breezer dealer.
Warning: You should never cl
amp the frame when placing this bike in a repair stand. Always clamp the seat post.
Clamping the frame can cause serious damage to the frame which may not be visible. This will impair the structural
integrity of the frame. Failure to follow this warning may result in serious injury or death.
Your Breezer frame does not require any pre-installation preparation to the bottom bracket or head tube. Surfaces are prepared at
the factory. Grease will still need to be placed on the bottom bracket threads and the head set cups. If necessary, you may need to
chase the bottom bracket threads.
BOTTOM BRACKET:
Clean and grease bottom bracket shell threads before installing. Recommended torque is 442 in-lbf (50 N-m). Do not exceed
maximum torque of 670 in-lbf (70 N-m).
56
To Next Page
Loading...