Asko D5233 - Troubleshooting Common Issues; Addressing Poor Cleaning Results

24
Setting a signal
If you want the machine to signal when the wash is complete, you can program it to do this.
The machine is set without a signal by default.
1. Switch off the dishwasher at the main switch.
2. Hold in the Delayed start button at the same time as you press the
main switch. The button flashes. Release the button.
PROG PROG
3. Press the Program button – when the Auto wash symbol lights, the
signal is activated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next
time you want to make a change.
or Reset
1. Switch off the dishwasher with the main switch.
2. Hold in the Delayed start button at the same time as you press the
main switch. The button flashes. Release the button.
PROG PROG
3. Press the Program button – when the Auto wash symbol goes out, the
signal is deactivated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next
time you want to make a change.