If the dishwasher is turned off using
the On/Left-on mode button or due
to a power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
Once the program has finished
Once the program has finished, “End” appears on the display.
At the end of the program, you will hear a short beep. Chapter
Settings describes how to change this function.
Once the dishwasher has finished, it only uses standby power.
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
17 in the chapter Technical information.
9
To Next Page
Loading...
