1. Press the button once to activate Delayed Start. Press the button
several times – or hold it in – to set the desired number of hours.
2. Press Start/Stop and close the door. The timer counts down and
the dishwasher starts after the selected delay.
If you want to cancel the Delayed Start option, open the door then
press and hold Start/Stop for three seconds.
Starting the dishwasher
Press Start/Stop until the display shows "Program started, close door
in 4 sec". This indicates that the dishwasher is ready to start. Close the
door properly within four seconds, otherwise the dishwasher will not
start.
If the dishwasher is not started or the door is not closed within 2 minutes
of the last button press, the machine switches off.
Time remaining
Once you have chosen a program, program mode, and options, the
time the program took when last used is displayed.
Stopping or changing a program
If you want to change the program after starting the dishwasher, open
the door then press and hold Start/Stop for three seconds. Add more
detergent if the lid of the detergent dispenser has opened. Then choose
a new program, press Start/Stop, and close the door within four
seconds.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes.
Press Start/Stop and close the door within four seconds.
WARNING!
If the door is open, "Program paused" is shown on the display. If you
want the dishwashing program to continue, press Start/Stop and
close the door immediately. If you want to cancel the dishwashing
program, press and hold Start/Stop for three seconds.
If the dishwasher is turned off due to a
power failure
If the program was not finished, the interrupted program resumes when
power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or the
door is open for more than 2 minutes.
Once the program has finished
The end of the program is indicated by one short signal from the buzzer.
The chapter Settings describes how to change this function.
The dishwasher switches off automatically after the program ends.
To minimize the risk of leaks, we recommend that you turn off the water
supply valve if away from home for an extended period of time.
How to get the best drying results
• Fully load the dishwasher.
• Angle dishes with hollows, such as cups, so that the rinse water
will run off. This is also important for plastic items.
• Top up with rinse aid or increase the rinse aid dosage level.
• Activate the Extra Dry option.
• Activate the High temperature setting. See the chapter Settings.
• Open the door a little once the program has finished.
• Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher
before unloading them.
Unload the lower basket first to avoid any water drops from the upper
basket falling onto the dishes in the lower basket.
11
To Next Page
Loading...
Need help?
General
Weight and Dimensions
