Unblocking the drain pump
If the dishwasher still contains water after the program has finished,
something may be blocking the drain pump. Such items are easily
removed.
1 Turn off the machine using the main power switch and unplug it
from the power outlet.
2 Remove the coarse filter and the fine filter.
3 Scoop out the water from the dishwasher tub.
4 In order to inspect the drain pump, remove the colored stop on the
right in the bottom drain.
5 Turn the pump wheel located behind the drain pump stop by hand.
Carefully remove any items.
6 Replace the drain pump stop along with the fine and coarse filters.
7 Plug the machine in again.
If the dishwasher still does not start and a whirring sound is heard,
the overflow protection has been triggered.
• Shut off the water.
• Unplug the unit from the power outlet.
• Call the Customer Care Center.
NOTE!
Do not forget to replace the drain pump stop.
15
To Next Page
Loading...
Need help?
General
