Page 2
Customer Care Center
1-800-898-1879
www.askousa.com
TOOLS
1) Phillips No. 2 screwdriver
2) Flat blade screwdriver
3) Torx screwdriver size T 20
4) Adjustable wrenches (if you use copper ttings)
5) Open-ended wrench (1/2˝ [12 mm] or 5/8˝ [16 mm])
6) Tape measure
7) Spirit level
8) Electric drill with 1-1/2˝ drill bit
9) Keyhole saw
Read these instructions carefully and completely before
you install the machine. The installation should be carried
out by a qualied person who is familiar with all local codes
and ordinances for electrical and plumbing connections.
If a dishwasher is being installed in this area for the rst
time, most of the cabinet work, plumbing, and electrical
has to be done before you move the machine into place.
If you are replacing an old dishwasher, you must check
the plumbing connection and wiring before you move the
new dishwasher into place.
Tip Guards
(P/N 8070851)
The dishwasher is shipped with the high loop drain hose,
inlet hose and electrical cord attached and ready to
be connected.
• Minimum 3/8˝ OD copper tubing of
sucient length for your installation
• Shut-o valve and ttings for water
supply line
Tip Guards (optional)
When it is not possible to attach the dishwasher to the
cabinet or the underside of the counter top, you should
install tip guards to prevent the machine from tipping when
you open the door. Sold individually.
* Only select models.
2x
1"
(25 mm)
2x
4x / 3x
2
5
4
3
1
*
*
To Next Page
Loading...
