Asko DW70 - Water Level

29
6.3 Water level DW70
When servicing a DW70 dishwasher it is
important to check the water level in the
machine.
This is particularly important when program-
ming the time-controlled water intake. Too
low a water level can cause poor dishwashing
results.
Always allow the machine to take in and drain
the water a few times before checking the level.
In the event of too low a water level, the lter
in the inlet valve must always be checked and
rinsed clean of any dirt. The inlet hose with a
¾" connection at both ends has a lter in the
connector outside the machine that must also
be checked and rinsed clean of any dirt.
Figure: Check the level against the lower spray
arm hub
Overow level = 4.7 litres
Without spray arm diverter = 3.2
litres
(1.5 mm above the level)
With spray arm diverter = 2.8 litres
(0.5 mm below the level)
TROUBLESHOOTING