Rinse holes under the agitator
If you think that objects such as nails, paper
clips, needles or the like may have fallen
into the wash drum, you should check
under the agitator. Such objects can rust
and cause spots on clothing. Nails and
other sharp objects can cause holes in
fabrics.
Do as follows:
1. Use a screwdriver or similar tool.
2. Insert the screwdriver into the central
hole on the agitator and twist the
screwdriver handle gently to the left.
3. With your other hand, grasp the agitator
and pull it towards you as shown in the
illustration.
4. Lift the agitator.
5. Remove any objects.
6. Place the agitator in the mounting hole
with the F-mark towards you. Ensure that
all the agitator fasteners are in their holes
in the drum. Push it away from you until it
catches.
If you have hard water
If you live in an area with hard water (lime
heavy), the washer drum may develop a
greyish-white coating. To get rid of this,
empty a sachet of citric acid, approximately
20 gram, into the washer drum and run the
Heavy programme with pre-wash at 90°C.
You can find citric acid among the spices,
etc. at your local supermarket.
To Next Page
Loading...
