11
Step by step instructions to help you achieve
the best washing results.
1 - PRESS THE BUTTON
Press the button to open the door and put
the washing in.
2 - PUTTING IN THE DETERGENT AND CON-
DITIONER
Follow the recommendations on the detergent
packet for how much detergent should be used.
The capacity of the machine is for 5.5 kg wash-
ing. If you put a smaller amount in the machi-
ne, you can reduce the amount of detergent
accordingly.
Powder detergent
Pour in the powder for main wash ( ) and any
pre-wash ( ).
Liquid detergent
A partition piece for liquid detergent is provi-
ded, you will find it attached un-
derneath the detergent compart-
ment. Take it and insert it in the
slot furthest in in the
compartment as illus-
trated. Pour the deter-
gent direct into the
main wash compartment (
).
8 WASHING
Detergent ball or dosing bag
If you are using a detergent ball or dosing bag,
put it in with the washing and select a program-
me without pre-wash.
Conditioner
Pour conditioner in the compartment marked
. Follow the maker’s instructions regarding
the amount.
NOTE.
Do not exceed the maximum dose level of the
container, the conditioner will otherwise flow
in too soon and deteriorate the washing effect.
3 - SELECTING SETTINGS AND OPTIONS
Set the knob for temperature and spin, and also
press suitable option buttons for a program to
suit the particular washing.
Temperature
Set the desired temperature with the tempera-
ture knob. If you choose 0°C the temperature
will be the same as that of the incoming water.
Spin speed
Set the desired spin speed with the spin speed
knob.
If you choose
the program will end with
the final rinse water remaining in the machine.
This is a suitable choice if you are unable to
take the washing out promptly at the end of the
program. The washing will remain floating in
the rinse water and thus counteract creasing.
You can later choose to run one of the spin
programs 5 and 8 or the drain program 10, to
drain off the rinse water.
Conditioner
Pre-wash
Main wash
To Next Page
Loading...
