Built-in installation
ASKO washers can be installed beneath a cabinet
or worktop with a height of 34" to 35" (863 to 889
mm) or in a closet. There must be a gap of about
½" (12 mm) all around the machine, including
between the rear edge of the machine's top panel
and the back wall. The opening width must be at
least 24½" (622 mm). Space must also be
available for the fill and drain hoses. See the
illustration below for measurements and positions.
If the washer is installed in a closet the door must
be left open while the washer is running.
If the drain outlet is higher than 24"(610 mm), the
connections will need to be recessed.
31Customer Care Center
1-800-898-1879
www.askousa.com
Installation
To Next Page
Loading...
Need help?
General
