Built-in installation
ASKO washers can be installed beneath a cabinet
or worktop with a height of 34½" (876 mm) or in
a closet. There must be a gap of about ½" (12
mm) all around the machine, including between
the rear edge of the machine's top panel and the
back wall. The opening width must be at least
24½" (622 mm). Space must also be available for
the inlet and drain hoses. See the illustration
below for measurements and positions. If the
washer is installed in a closet the door shall be
opend while the washer is running.
If the drain outlet is higher than 24"(610 mm), the
connections will need to be recessed.
31Customer Care Center
1-800-898-1879
www.askousa.com
Installation
To Next Page
Loading...
