31
Customer Care Center
1-800-898-1879
www.askona.com
Installation
Read these instructions carefully and
completely before you install the machine. The
installation should be carried out by a qualied
person who is familiar with all local codes
and ordinances for electrical and plumbing
connections.
Cosmetic damage must be reported to
your dealer within ve days from the date
of purchase. After unpacking the washer,
thoroughly check the unit for cosmetic damage.
Leveling the machine
It is important that the machine is level to
prevent excessive vibrations during spin cycles.
Each foot of the washer is adjustable, so you
can level the washer on any surface. Once it
is level, securely tighten the lock nuts on the
feet to prevent excessive vibration during spin
cycles.
Be sure to tighten the
lock nuts securely
when you level the
machine.
Water supply connection
Since ASKO washers have a built-in heating
element, you only need a cold water inlet. The
connection should be made by someone who
is suciently skilled. Use the hose supplied
with the washer. (The inlet hose is marked for
correct connection.) The water pressure must
be in the range 15–146 PSI. A valve should be
tted on the water supply pipe. If a new supply
pipe has been installed for the washer, it should
be ushed thoroughly to remove any foreign
particles that might clog the lter in the ll valve.
NOTE!
If the unit is installed on a second storey, follow
local building codes. We recommend installing
a drip pan.
To Next Page
Loading...
