33
Customer Care Center
1-800-898-1879
www.askona.com
Installation
Built-in installation
ASKO washers can be installed beneath a
cabinet or worktop with a height of 34” to 35”
(863 to 889 mm) or in a closet. There must
be a gap of about ½” (12 mm) all around the
machine, including between the rear edge of
the machine’s top panel and the back wall.
The opening width must be at least 24½” (622
mm). Space must also be available for the ll
and drain hoses. See the illustration below for
measurements and positions. If the washer is
installed in a closet the door must be left open
while the washer is running.
If the drain outlet is higher than 24"(610 mm), the
connections will need to be recessed.
To Next Page
Loading...
