Asko WM70.C - Technical Data and Tools; Required Tools for Servicing

Service manual WM70.C
21
Technical data
Height: 850 mm
Width: 595 mm
Depth: 585 mm
Weight: 73 kg
Cylinder volume: 60 l
Max. load capacity 8 kg/6 kg
Spin speed: 800-1600
Connection: 1-phase 16 A, 3-phase 10 A
Heater output: 2000 W/3000 W
Water pressure/inlet valve: 0.1–1 MPa, 1–10 kp/cm2, 10–100 N/cm2 8 l/min
Wash drum and liquid
compartment:
Stainless steel
Outer panels: Powder-coated and hot-galvanised sheet steel or stainless steel
Installation: Stationary on four adjustable, rubber-clad feet
Water connection: 1.5 m PEX tubing, 3/4"–3/4" or 3/4"–1/2"
Drainage: 1.7 m polypropylene tubing
Protection class: IP X4
Water consumption (tested normal
programme)
59 litres, 3 rinses (5 kg/6 kg
<72 litres, 5 rinses (6 kg)
<69 litres, 5 rinses (5 kg)
Water consumption (tested normal
programme)
1.02 kWh (6 kg)
0.95 kWh (5 kg)
Electricity consumption, Standby:
- Machine turned off
- Delayed start
- Programme ended
<0.3 W
<6.0 W
<3.0 W
Tools
Torx: T25, T20, T10
Ring spanner: 11/16", 16 mm, 13 mm,
10 mm
Socket screwdriver 10 mm
Extended socket 24 mm + ratchet
handle
Allen key 5 mm + small ratchet handle
Plastic hammer
Phillips screwdriver
Wire cutter