What causes unsatisfactory washing results with Aspes ALF1812 Washer?
If your Aspes Washer provides an unsatisfactory washing result, it might be due to hard water. In this case, increase the amount of detergent, following the manufacturer’s instructions. Also, make sure that your laundry is spread out in the drum and not too tightly packed together.
How to fix Aspes ALF1812 that won't start?
If your Aspes Washer doesn't start, there are several potential causes. Ensure the machine is properly plugged in and that the fuses are not faulty, replacing them if necessary. Verify that there's mains power supply. Also, confirm that you've pressed the Start/Pause button and that the program dial is set to the desired position, not the 'stop' position. Finally, make sure the machine door is completely closed.
What to do if my Aspes ALF1812 Washer is not intaking water?
If your Aspes Washer isn't intaking water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or the inlet filters might be clogged, so clean them. Ensure that the machine door is completely closed.
Why is my Aspes Washer vibrating so much?
If your Aspes Washer vibrates, make sure the feet have been adjusted properly. Check that the transit bolts, which are fitted for transportation, have been removed. Avoid setting up your washing machine on a hard surface. Ensure that you do not overload the drum and that the laundry is spread evenly. Note that a small load in the drum will not prevent the operation of your machine.
How to fix Aspes Washer that won't drain water?
If your Aspes Washer isn't discharging water, check the drain hose for clogs or twists, and clean or untwist it as needed. Clean the pump filter. Ensure that your laundry is not too tightly packed together in the drum; spread it evenly.
Why is there too much foam in my Aspes Washer detergent drawer?
If you observe excessive foam in the detergent drawer of your Aspes Washer, it could be due to using too much detergent or using the wrong type. Press the Start/Pause button. To stop the foam, dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button after 5-10 mins. Only use detergents specifically produced for automatic Washing Machines.
Why is my Aspes Washer not cleaning clothes properly?
If your Aspes Washer provides an unsatisfactory washing result, consider whether your laundry is too dirty for the selected program; refer to the program tables to choose a more appropriate one. Ensure you're using the correct amount of detergent as instructed on the packaging. Also, check that you have not exceeded the maximum laundry capacity for the selected program.
Why does water immediately discharge from my Aspes ALF1812 Washer?
If water discharges as soon as the Aspes Washer is loaded, check that the drain hose is at a suitable height.
How to remove detergent residue from laundry after washing with Aspes Washer?
If your laundry has detergent residue after washing in your Aspes Washer, it may be due to non-dissolving particles in some detergents appearing as white spots. To resolve this, perform an extra rinse cycle, or clean your laundry with a brush after it dries.
Why do grey spots appear on laundry after washing in Aspes ALF1812 Washer?
If grey spots appear on your laundry after washing with your Aspes Washer, it could be due to untreated oil, cream, or ointment on the items. Use the amount of detergent as instructed on the packaging in the next wash.
To Next Page
General
