How to improve Aspes Washer results with hard water?
If you're getting unsatisfactory washing results from your Aspes Washer and you have hard water, try increasing the amount of detergent you use, following the manufacturer’s instructions. Also, make sure your laundry is spread out in the drum.
How to fix an Aspes ALF21410 that won't start?
If your Aspes Washer doesn't start, make sure it's properly plugged in and the fuses aren't faulty (replace them if they are). Check that there's mains power and that you've pressed the Start/Pause button. Also, ensure the program dial isn't on the 'stop' position and that the machine door is completely closed.
Why is my Aspes Washer not taking in water?
If your Aspes Washer isn't intaking water, start by checking if the water tap is turned on. Then, inspect the water inlet hose to ensure it's not twisted or clogged. Clean the water inlet hose filters and the inlet filters themselves. Finally, make sure the machine door is completely closed.
What to do if my Aspes ALF21410 won't drain water?
If your Aspes Washer isn't discharging water, first check the drain hose for any clogs or twists, and clean or untwist it as needed. Next, clean the pump filter. Also, make sure your laundry isn't packed too tightly in the drum; spread it out evenly.
Why is my Aspes Washer vibrating so much?
If your Aspes Washer is vibrating, adjust the feet to ensure it's stable. Remove any transit bolts that were fitted for transportation. Note that a small load might cause some vibration but won't prevent the machine from operating. Avoid overloading the drum and spread laundry evenly. Also, don't place your washing machine on a hard surface.
How to stop excessive foam in my Aspes ALF21410 Washer detergent drawer?
If you observe excessive foam in the detergent drawer of your Aspes Washer, it's likely due to using too much or the wrong type of detergent. To stop the foam, press the Start/Pause button. Then, dilute one tablespoon of softener in 1/2 litre of water, pour it into the detergent drawer, and press the Start/Pause button again after 5-10 minutes. Make sure you only use detergents specifically produced for automatic washing machines.
Why are my Aspes ALF21410 Washer results unsatisfactory?
If you're not getting satisfactory washing results with your Aspes Washer, make sure you've selected the most appropriate program for how dirty your laundry is, using the program tables as a guide. Ensure you're using enough detergent as instructed on the packaging. Also, check that you haven't exceeded the maximum laundry capacity for the selected program.
Why does my Aspes Washer discharge water immediately after loading?
If your Aspes Washer discharges water as soon as it's loaded, make sure the end of the water drain hose is at a suitable height for the machine.
How to remove detergent residue from Aspes ALF21410 Washer laundry?
If your laundry has detergent residue after washing in your Aspes Washer, it might be due to non-dissolving particles in some detergents that appear as white spots. Try performing an extra rinse or cleaning your laundry with a brush after it dries.
Why are there grey spots on my laundry after using my Aspes ALF21410?
If grey spots appear on your laundry after washing in your Aspes Washer, it may be due to untreated oil, cream, or ointment on the items. In the next wash, use the amount of detergent as instructed on the packaging.
General| Category | Washer |
|---|---|
| Capacity | 10 kg |
| Energy Efficiency Class | A+++ |
| Spin Speed | 1400 RPM |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
To Next Page
