Why won't my Aspes ALV137X Dishwasher start?
There are several reasons why your Aspes Dishwasher might not start. First, ensure the dishwasher is properly plugged in and switched on using the On/Off button. Check your indoor fuses and make sure the water inlet tap is open. Also, verify that the dishwasher door is fully closed and that the water inlet hose and machine filters are not clogged.
How to prevent food waste on dishes after using Aspes ALV137X?
To prevent food waste from remaining on dishes after using your Aspes Dishwasher, avoid overloading the baskets and ensure dishes aren't leaning against each other. Use the correct amount of detergent as instructed in the programme table and select the most appropriate wash programme. Clean the holes in the spray arms with thin objects and check that the drain hose and filters are correctly fitted.
What to do if water remains inside Aspes ALV137X Dishwasher?
If water remains inside your Aspes Dishwasher, start by checking the drain hose for any clogs or twists; clean or untwist it as needed. Then, clean the filters. If the dishwasher is still running its program, wait until it is finished.
How to remove whitish stains from dishes in Aspes ALV137X Dishwasher?
To remove whitish stains from dishes in your Aspes Dishwasher, ensure you are using the correct amount of detergent as per the programme table. Also, increase the rinse aid dosage and/or water softener level. If you have hard water, increase the water softener level and add salt. Finally, check that the salt compartment cap is closed properly.
Why are there rust stains on dishes from my Aspes ALV137X?
Rust stains on dishes from your Aspes Dishwasher can be due to several reasons. The stainless-steel quality of your dishes might be insufficient, so use only dishwasher-proof sets. A high level of salt in the wash water can also cause rust, so adjust the water hardness level using the water hardness table. Ensure the salt compartment cap is closed properly and use a funnel when filling with salt to avoid spillage. A poor mains grounding might also contribute.
Why Aspes Dishwasher leaves dishes wet?
If your Aspes Dishwasher leaves dishes wet, make sure that a programme with a drying option is selected. If it is, try increasing the rinse aid dosage setting.
Why does my Aspes Dishwasher stop during washing?
Your Aspes Dishwasher might stop during washing due to a power failure. Check your mains power. It could also be due to a water inlet failure, so check the water tap.
How to stop shaking noises during Aspes ALV137X operation?
Shaking and hitting noises during a wash operation in your Aspes Dishwasher usually mean the spray arm is hitting dishes in the lower basket. Try moving or removing items that are blocking the spray arm.
Why detergent remains in the detergent compartment of my Aspes Dishwasher?
If detergent remains in the detergent compartment of your Aspes Dishwasher, it may be because the detergent was added when the compartment was wet. Make sure the detergent compartment is dry before use.
What to do if Aspes ALV137X Dishwasher shows insufficient water?
If your Aspes Dishwasher shows insufficient water, make sure the water inlet tap is open and water is flowing. Separate the inlet hose from the tap and clean the filter of the hose.
General| Type | Freestanding |
|---|---|
| Place Settings | 12 |
| Energy Rating | A++ |
| Child Lock | Yes |
| Programs | 6 |
| Delay Start | Yes |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
To Next Page
