ASROCK Rack D2163D8UM - Page 24

18 19
English
Consult the documentation that comes with your SATA DOM and check whether or not
Pin 7 requires 5V power supply.
If the connected SATA DOM requires 5V power supply, move the jumper caps placed on the
SATA DOM Power Jumper (SATAPWR1) from pins 2-3 (default) to pins 1-2.
If the connected SATA DOM does NOT require 5V power supply, connect the SATA DOM
power cable to the SATA DOM power header (SATAPWR1) and there is no need to change
the default jumper setting of the SATA DOM Power Jumper (pins 2-3).
Warning! Incorrect setting of the SATA DOM Power Jumper (SATAPWR1) may cause dam-
age to the motherboard or your SATA DOM.
Enable/Disable BMC Jumper
(3-pin BMC_DIS1)
(see p.6, No. 46)
Normal Mode (Default)
BMC Enabled
BMC Disabled
NCSI Mode Jumper
(3-pin NCSI_SEL1)
(see p.6, No. 45)
No Function NCSI is set to Mezzanine
Card (Default)
SATA DOM Power Jumper
(3-pin SATAPWR2)
(see p.6, No. 28)
SATA DOM (SSATA_3)
requires 5V power supply
SATA DOM (SSATA_3)
does NOT require 5V power
supply (Default)