(19-pin USB3_11_12)
(see p.1, No. 11)
Front Panel Audio
Headers
(9-pin HD_AUDIO1)
(see p.1, No. 31)
(9-pin HD_AUDIO_RA1)
(see p.1, No. 30)
is header is for
connecting audio devices
to the front audio panel.
* Connect the audio
device to either one of the
audio connectors.
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.1, No. 33)
(4-pin CHA_FAN2)
(see p.1, No. 27)
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
1. High Denition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to connect
them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel and
adjust “Recording Volume”.
To Next Page
Loading...
