Aperio
®
Online Mechanical Installation Guide, Document No: ST-001323-B Date: 21 februari 2014 43
Aperio
®
Online
Addressing table – legacy address offset
Legacy addressing mode is an alternative
addressing mode that can be set by the
Programming Application in the configuration
wizard. The lock addresses in this mode are set
consecutively. For example, if communication hub
has address 1, the locks will get address 1-8, 9-16,
17-24 etc.
DIP 5 – DIP 1 AH30 Hub address Lock addresses
0000 Reserved
0001 0x01 0x01, 0x02, 0x03, 0x04, 0x05, 0x06, 0x07, 0x08
0010 0x02 0x09, 0x0A, 0x0B, 0x0C, 0x0D, 0x0E, 0x0F, 0x10
0011 0x03 0x11, 0x12, 0x13, 0x14, 0x14, 0x16, 0x17, 0x18
0100 0x04 0x19, 0x1A, 0x1B, 0x1C, 0x1D, 0x1E, 0x1F, 0x20
...
This mode is used for older EAC systems that
cannot handle high EAC addresses where the limit
for example is 32 or 64.
To Next Page
Loading...
