2
ELECTRONIC KEYPAD LEVERSET
WITH BLUETOOTH PROGRAMMING
Using the Lock
Once installed on door with the battery connected - your lock is ready for use.
Factory Default Setting
User & Master Codes are labeled on the inside trim plate and page 7 of this user manual.
Entering User Codes
- Entering a correct, active user code (green LED x1 & beep x1) - unlocks
- Entering an incorrect or inactive code (red LED x2 & beep x2) - remains locked
- Three incorrect entries will result in lockout, signaled by 3 red LED ashes & 3 short beeps,
lockout lasts for 30 seconds.
To Restart Code Entry
Press and hold # 1 button for three seconds (this works in entry or programming mode).
Key Access
Lock may also be unlocked and locked via keyed cylinder, each lock comes with two keys.
Passage & Privacy Mode
Use inside thumbturn.
Setting Setting Description Thumbturn Position LED Feedback
Thumbturn
Enable ON
Thumbturn
Enable OFF
Green
Amber
Lock access is regulated.
A correct, active user code
is required for access.
(Privacy Mode)
Lock access is NOT regulated
Always Unclocked.
(Passage Mode)
Lever buttons
Thumbturn
Keyed Cylinder
To Next Page
Loading...
