12/04/2016 - 8 - Concept
In lower version of the TS1000, the services of the TS1000 software must be stopped before this program can be used.
This newer version will check if these services are still running and will ask if these services may be stopped.
Accept that the services may be stopped.
The program will stop every service necessary and continue the process.
This can take some time depending on your PC configuration.
If this is an complete new hub (never been used before)
Reset the hub and click on the Verify HUB Reset button. See procedure point 8
On the left you will see your own IP address of your PC.
In the middle, you will see the current IP address of the hub.
To Next Page
Loading...
