6-5
SORGENTE/SMILE/ISI-T/UNDERCOUNTER - Installation, User and Maintenance - cod. A-MAN03 - Rev. 02/2012
Proceed as follows:
1 the User Menu is accessed by pressing the rear Menu
Access Key for at least 3 seconds – or until the beep
is heard;
2 release the Rear Key, the [REFRIGERATOR TEMP] mes-
sage will be displayed followed by the value set;
3 prthen press the rear menu access key until [DOSING]
appears on the display; it will be pre-set on the default
value [OFF]. By operating on the
or
keys it
is possible to change the value from [OFF] to [ON(T)]
and then enable the water dosing;
4 when the desired value is set, press the rear key
repeatedly until the [SAVE SETTINGS?] message is
displayed;
5 press simultaneously the keys
and
to save the
settings; the [OK SAVED] message should be displayed
followed by a confirming beep. After few seconds the
display will automatically show the home screen.
Now the dispenser is ready to receive the automatic dosing
settings for timed water dispensing for the single available
waters; press the rear key for an instant and dispense the
desired quantity of water and this value will be automa-
tically saved when the key is released.
Repeat the same operation for all the available types of
water.
Repeat this procedure every time it is necessary to change
the quantity of automatically dosed water dispensing.
6.5 Enable Tone
The Enable Tone function allows to enable/disable anyacustic
notification everytime a key is pressed. Default value=ON.
ATTENTION
In all dispensers the automatic
timed water dispensing program
is not enabled for default
and therefore – if desired –
it is necessary to enable it.
CAUTION
To stop unintentional dispensing
just press any key!!!
R e f r i g e r a t o r T e m p
+ 6 . 0
D o s i n g
O F F
S a v e S e t t i n g s ?
O K S a v e d
S a v e S e t t i n g s ?
E n a b l e T o n e s
O N
To Next Page
