Associated Electrics PRO4 SC10 - Introduction and Features; Pro4 SC10 RTR Features; Notes and Additional Items

2
:: Introduction
:: Pro4 SC10 RTR Features
:: Additional
:: Other Helpful Items
Thank you for purchasing this Team Associated product. This assembly manual contains instructions and tips for building and
maintaining your new vehicle. Please take a moment to read through the manual and familiarize yourself with the steps.
We are continually changing and improving our designs; therefore, actual parts may appear slightly different than the illustrations.
New parts will be noted on supplementary sheets located in the appropriate parts bags. Check each bag for these sheets before
you start to build.
• 2.4GHz 2-channel radio system
• High-Torque Digital Servo with spring-style servo saver
• Reedy Sport 550 15T Brushed Motor
• Reedy Water-resistant brushed ESC with T-plug connector and LiPo low-voltage cutoff
• Three sealed gear differentials
• Fifteen52 Turbomac HD wheels
• Threaded Oil-filled coil over shock absorbers
• 4mm heavy-duty adjustable alloy steel turnbuckles
• Durable slider type drive shafts
• Factory-finished Contender short course body
• High-grip General Tire GT(R) Grabbers all terrain tires
• Steel center drive shaft
• Four-wheel independent suspension
• Durable, impact-absorbing front and rear bumpers.
Associated Electrics, Inc.
21062 Bake Pkwy.
Lake Forest, CA 92630
http://www.RC10.com · http://twitter.com/Team_Associated · http://www.instagram.com/teamassociatedrc/ · http://www.facebook.com/TeamAssociated/
Customer Service
Tel: 949.544.7500
Fax: 949.544.7501
Your new Pro4 SC10 comes assembled. The following items are needed for completion.
• (4) AA batteries
Tools included: • 1.5mm, 2.0mm, 2.5mm Wrenches
• Silicone Shock Fluid (Refer to catalog for complete listings) • Silicone Diff Fluid (Refer to catalog for complete listings)
• Body Scissors (AE Part # 1737) • Reamer / Hole Punch (#1499) • Shock Pliers (#1675) • Wire Cutters
• FT Hex/Nut Wrenches (AE Part # 1650)• Needle Nose Pliers • Hobby Knife • Soldering Iron
• Calipers or a Precision Ruler • Green Slime shock lube (AE Part # 1105)
• FT Turnbuckle Wrench (#1114) • FT Universal Tire Balancer (#1498)
:: Table of Contents
1................... Cover
2................... Introduction
3...................1:1 Hardware “Fold Out”
4 - 5............. Quick Start Guide
6 - 19............Steps 1- 41
20.................Tuning Tips
21.................Catalog/Notes
22................Back Cover
:: Notes
This symbol indicates a special note or instruction in the manual.
!
There is a 1:1 hardware foldout page in the front of the manual. To check
the size of a part, line up your hardware with the correct drawing until you
find the exact size. Each part in the foldout has a number assigned to it
for ordering replacement parts.