4
:: Quick Start Guide
Battery Charging and Safety:
Before charging your battery for the first time, please read the document Important Safety Instructions and Warnings
found in the documents bad included with your vehicle.
Charging
1. To prepare the battery for charging, remove the battery from the vehicle and place it on a fire-proof surface
[image 1] free from moisture and the potential for contact with water or any other liquids.
2. Plug the USB end of the charge cable into a 5V USB port [image 2].
Flashing red/green LED lights indicate the the charger is powered and is ready to use.
3. Plug the battery’s 3-pin male connector into the charge cable’s 3-pin female connector [image 3].
The red LED light will remain on to indicate that the battery is successfully charging.
4. The charge is complete when the red LED light goes out and the green LED illuminates.
5. Unplug the battery from the charger cable and then unplug the USB plug from USB port.
6. Your battery is now ready to use!
CAUTION! Failure to abide by the following may result in fire, property damage, and/or loss of life.
• Never leave the battery unattended while charging.
• Always remove the LiPo battery from the vehicle and place it on a fireproof surface while charging.
• Always disconnect the battery from the charge cord, and the charge cord from the USB port, when finished charging
and when the charge cable is not in use.
• Always disconnect the battery from the vehicle when you are finished driving the vehicle and whenever the vehicle is
not in use.
• Always store LiPo batteries in a fireproof container when not being used.
• Always use a charger specifically designed and engineered to charge LiPo batteries.
Battery Installation:
1. Install the battery with the battery wires directed towards
the rear of the vehicle.
2. Secure the battery strap using two hook and loop straps.
1 2
Image 1
Image 2 Image 3
To Next Page
Loading...
