Associated Electrics RC10 Classic - Important Notes and Guidance; Hardware Identification Guide

3
:: Table of Contents
:: Notes
This symbols indicates a
special note or instruction
in the manual.
!
There is a 1:1 hardware foldout page in the back
of the manual. To check the size of a part, line
up your hardare with the correct drawing until
you find the exact size. Each part in the foldout
has a number assigned to it for ordering
replacement parts.
1................... Cover
2................... Introduction
3................... Table of Contents
4....................Nose Plate / Steering Build
(Bag A-AA)
4 - 5............. Front Suspension Build
(Bag B)
6 - 9.............Transmission Build
(Bag C-CC)
9 - 10...........Rear Bulkhead Build
(Bag D-DD)
10 - 11.........Rear Suspension Build
(Bag E-EE)
11 - 12........ Turnbuckles Build
(Bag F)
12 - 14........ Shocks Build
(Bag G-GG)
15 ................Chassis Build
(Bag H)
15 - 17........ Electronics Build
(Bag I)
17 - 19....... Wheels, Tires and Body Install
(Bag J)
20 - 21....... Tuning Tips
22 - 30....... Catalog
31................ Setup Sheet “Kit Setup”
32................ 1:1 Hardware “Fold Out”
33................ Setup Sheet “Blank”
34................ Back Cover
Associated Electrics, Inc.
26021 Commercentre Dr.
Lake Forest, CA 92630
http://www.TeamAssociated.com · http://www.RC10.com · http://twitter.com/Team_Associated · http://bit.ly/AEonFacebook
Customer Service
Tel: 949.544.7500
Fax: 949.544.7501