Associated Electrics RC8B4.1e Team Kit - Front Gearbox Assembly - Steps 3-5; Arm Mounts and Hinge Pins; Anti-Roll Bar Installation

12
:: :: Front Gearbox Front Gearbox BuildBuild - Bag - Bag 5.1, 5.2, 5.35.1, 5.2, 5.3 -- Step 4Step 4
:: :: Front Gearbox Front Gearbox BuildBuild - Bag 5.1, 5.2, 5.35.1, 5.2, 5.3 -- Step 5
:: :: Front Gearbox Front Gearbox BuildBuild - Bag - Bag 5.1, 5.2, 5.35.1, 5.2, 5.3 -- Step 3Step 3
Center the anti-roll
bar collet on the anti-
roll bar, then tighten
the 3x3mm set
screw.
Front anti-roll
bar gap: 2.0mm
!
!
25225
3x3mm
Set Screw
81585
Anti-Roll
Bar
Collet
81129
(Front) Anti-Roll
Bar, 2.2mm
81260
4x14mm
BHCS
x2x2
81520
Arm Mount
Insert, Center
81567
Arm Mount
B
x2x2
Kit Setup:
81585
Anti-Roll
Bar Pivot
81512
Anti-Roll
Bar Link
81585
Rod End
Ball
x2x2
Note direction
Note direction
!
!
89203
3x16mm
BHCS
x2x2
Build left and right side!
81260
4x14mm
BHCS
x2x2
x2x2
x2x2
81566
Arm Mount
A
81060
Hinge
Pin
81446
Suspension
Arm Shim
81528
Front Arm,
Lower
89317
Droop
Screw
Droop Screw:
Kit Setup:
1.5mm
81520
Arm Mount
Insert, Center
x2x2
Start here,
adjust to
101mm
shock length.
!
Center!
!