Associated Electrics RC8B4.1e Team Kit - Rear End Assembly - Steps 4-6; Suspension Arms and Anti-Roll Bars; Anti-Roll Bar Tuning and Pivot Ball Alignment

17
:: :: Rear End Build - Bag 7.1, 7.2, 7.3 - Step 5
:: :: Rear End Build - Bag 7.1, 7.2, 7.3 - Step 6
:: :: Rear End Build - Bag 7.1, 7.2, 7.3 - Step 4Rear End Build - Bag 7.1, 7.2, 7.3 - Step 4
25225
3x3mm
Set Screw
81150
Anti-Roll
Bar
Collet
81140
(Rear) Anti-Roll
Bar, 2.5mm
Droop Screw:
Kit Setup:
1.5mm
81638
B4.1 Rear
Suspension
Arm, soft
81585
Anti-Roll
Bar Pivot
81512
Anti-Roll
Bar Link
81648
PivotBall,
Offset
x2x2
81641
Hinge
Pin
x2x2
81446
Suspension
Arm Shim
81260
M4x14mm
BHCS
81455
Arm Mount,
HRC, Narrow
(D)
x2x2
81520
Arm Mount
Insert,
Center
x2x2
89317
Droop
Screw
25188
M3x20mm
BHCS
x2x2
25225
M3x3mm
Set Screw
31521
M2.5x8mm
BHCS
x2x2
x2x2
81257
M3x6mm
Set Screw
x2x2
Tighten 3x6mm set screws just enough to
still allow the anti-roll bar to move freely.
!
!
Kit Setup:
Rear Anti-Roll Bar Tuning:
Ball wide = more rigid,
less rotation (*kit)
Ball narrow = more soft,
more rotation
Pivot ball wide = flush (*kit)
Pivot ball narrow = 4mm
!
!
Center!
!