Infotainment System
4.15
Headsets
Warnings: Operating this vehicle at high engine speeds
will created high volume levels in the vehicle cabin which
can damage hearing. The supplied headsets should be worn
when the vehicle is driven.
This vehicle is supplied with a pair of aircraft grade noise-
cancelling headsets which should be worn whenever the vehicle
is driven. The headsets include a built in intercom to allow the
drive and passenger to talk in comfort and connect to the
infotainment system for music, navigation instructions and
telephone calls.
Connection
To connect the headsets to the vehicle, plug the connector from
the headset(s) into the fly leads found by the inner shoulders of
the seats. Once connected the headsets will be powered
whenever the infotainment system is on.
Adjustment
For the headsets to correctly provide hearing protection, the
headsets must be adjusted correctly. The headset should be worn
so that the head pad lightly touches the top of the head. The
vertical sliding assembly can then be adjusted to fit. The memory
foam on the ear pads will then shape to provide a seal around the
ears.
To adjust the microphone, move the boom up and down or in
and out by rotating and flexing the boom as necessary. The ideal
position for the microphones is approximately 3mm (1/8") from
the lips
Intercom and Infotainment
The headsets are permanently set to work as an intercom
between the driver and the passenger when the vehicle
infotainment is on. The infotainment also sends audio such as the
radio, music and phone, through to the headsets.
Care and Maintenance
To remove the ear pads, gently pull off the headset. To install,
carefully stretch over the lip of of the earpiece.
To remove the head pad, gently pull off from the headpiece of
the headset. To install, align the head pad with the head band
and push on to attach.
KY9Y-19A321-AA.book Page 15 Wednesday, November 3, 2021 8:41 AM
To Next Page
Loading...
