NOTE:
(j) Thetest unitof "Q"area is "Q"; Ifthe numberon the yellow
area is followed by a"M", then the test unit is "MQ"; If the
number on the yellow area is followed by a "K", then the test
unit is "KQ"
@ Choosea largermeasurementrangeto measurethe unknown
resistance first, then select the appropriate range according to
the resistance.
• Connect the test leads to both ends of the circuit or resistor
under test (connect the leads to the resistance under test in
parallel)
• After the reading stabilizes, record it from the LCD screen.
• Turn the rotary switch to the OFF position to turn off the Meter.
RESISTANCE NOTES:
• Do not change the resistance while taking a measurement.
Doing so may damage the Meter and affect the test results.
• Do not test parallel circuits. The accuracy of the measurement
will be affected, and the results may not be accurate
• Do not directly measure the internal resistance of micrometers,
galvanometers, batteries, and other instruments
V .CONTINUITY TEST :
• Insert the red test lead into the "VQmAJ1r" terminal and the black
test lead into the "COM" terminal.
• Turn the rotary dial to the " " setting. touch
the red and the black test leads to check
whether they are normal. The buzzer will beep
if the test leads are normal
-17
To Next Page
Loading...
