• Before using the meter, please check whether there are
cracks or damage to the plastic parts of the meter casing
Do not use the Meter if all or part of the exterior casing is
damaged
• Before using the Meter, please check whether the test leads
are cracked or damaged. Please replace the test leads with
the same model and same electrical specifications if the
leads are damaged.
• Comply with local and national safety regulations. Wear
personal protective equipment (such as approved rubber
gloves, masks, and flame-retardant clothing, etc.) to prevent
injury from electric shocks and arcs when hazardous live
conductors are exposed.
• Replace the battery as soon as the low-battery indicator
appears to avoid measurement errors
• Do not use the Meter around explosive gas or steam; or
humid environments
• When using the test leads, keep your fingers behind the
finger guards.
• Do not measure the current when a test lead is inserted into
the INPUT Terminal
• Do not let the Meter work alone without someone being
present.
• When measuring, connect the neutral wire or ground wire
first, and then connect the live wire; when disconnecting,
disconnect the live wire first, and then disconnect the neutral
wire and the ground wire.
• Before opening the case or battery cover, remove the test
leads from the Meter first. Do not use the Meter when it is
disassembled or the battery cover is opened.
• The Meter can only be used with the equipped test leads to
meet the requirements of safety standards. If the test leads
are damaged and need to be replaced, replace only with the
same model and the same electrical specifications.
-4
To Next Page
Loading...
