IMPORTANT NOTICE
TO INSTALLERS!
The control module included in this kit must be interfaced according to the
type of vehicle in which it is installed. The control module won’t, IN ANY
WAY, monitor the position of the gearshift lever during a remote start.
It is factory set to "Manual Transmission" mode.
See Stage 1 - Level 16 on page 22 for programming options.
• For vehicles equipped with a MANUAL TRANSMISSION
you must pay
special attention to the instructions identified with the following
pictogram and follow the corresponding instructions.
• When this product is installed in a manual transmission vehicle,
the installation must be done safely
using a manual interface
(not included – part no. RS-MI). This module is designed to force the user to ensure
that the gearshift lever is in neutral and that the parking brake is activated for the
system to proceed to ready mode for remote start.
• Make sure you deliver the User Manual to the customer
• Make sure you post the two warning labels in the appropriate locations:
the smaller one must be visible in the driver's side window;
the other must be placed near the hood release lever.
•
Make sure you hang the "For your safety" card on the rear-view mirror.
• Also make sure all verifications and testing (for automatic or manual transmission
vehicle) is done before and after the installation is done.
To Next Page
Loading...
Need help?
General
