EasyManuals Logo

AstroStart BBF User Manual

AstroStart BBF
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
27
CODE LEARNING OF TRANSMITTER (S)
ALL REMOTES INCLUDED IN ASTROSTART REMOTE STARTER KITS ARE FACTORY PROGRAMMED. THERE IS NO NEED TO
PROGRAM THEM AT THE INSTALLATION
.
Remote programming can be done in two different ways:
W
ITH THE DIP SWITCHES
The easiest and fastest way, when you have access to the control module, is by the Dipswitches.
Simply put the Dipswitch #8 to ON and press the brakes.
Enter all desired remotes, one after the other, to the memory slots of the control module by pressing any
button of the remote. (Be careful not to send a Panic command). When the programming of the remote
is done, the parking light switch will flash once and the control module LED will blink rapidly.
Repeat the above procedures for each remote control that has to be programmed. A maximum of 4
remotes can be programmed into a single control module.
Note: When the first code learning command is sent, all the old codes are cleared out. Therefore,
if you want to add a new remote, all the old ones must be reprogrammed as well.
Once the programming of all remotes is done, put Dip switch #8 back to OFF and press the brakes.
Remote(s) is (are) now programmed to the system and ready to use.
The memory slots 3 and 4 activate an output called “Ground when Unlock by User 2” allowing
different functions in the vehicle to be controlled by a different user when Unlocking.
W
ITH THE IGNITION KEY
One or more remote transmitters can be added without needing to access the remote start control module. To do so,
the programming is accessed as follows:
Open the hood and make sure the switch is making contact
Place key in the ignition and turn to the “RUN” position
Press on the brakes once
Within 10 seconds, turn the key from “RUN” to “STOP” position 3 times. If this sequence is correctly
carried out, the control module will flash the parking lights (4 flashes). You may then proceed to the next
step.
Press any button on the new remote control (be careful not to send a Panic command).
When access code of the new remote control is memorized, the control module will confirm with flashing
parking lights (1 flash).
Repeat the above procedure for each remote control that has to be programmed.
Note: When the first code learning command is sent, all the old codes are cleared out. Therefore,
if you want to add a new remote, all the old ones must be reprogrammed as well.
Once the remotes are learned, press on the brakes.
Remote(s) is (are) now programmed to the system and ready to use.
Memory slots 3 and 4 activate an output called “Ground when Unlock by User 2” allowing different
functions in the vehicle to be controlled by a different user when Unlocking.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AstroStart BBF and is the answer not in the manual?

AstroStart BBF Specifications

General IconGeneral
BrandAstroStart
ModelBBF
CategoryControl Unit
LanguageEnglish

Related product manuals