Asus BE24ECSBT - Page 7

3
1. Tear off Mylar and
disinsert Key Board wire
from Main Board.
2. Tear off 2 tapes from
lamp wire & Speaker
then disassemble cable
from Main Board.
3. Remove tapes from
cable.
4. Disassemble Shielding
from panel.
5. Disassemble Speaker
from Shielding.
6. Unlock 1 screws to
remove Sensor Board.
Screw :
(SCRW TAP CAP M3*6L B-
ZN)
Screw
driver
Torque :
4.5±0.5
Kg-cm
Remove tapes
Remove tapes
Remove tapes
Remove tapes
Do not paste the wire on the screw
Do not cross the cable
Paste under the line