Asus Blitz Formula - Page 106

4-32 Chapter 4: BIOS setup
South Bridge Overheat Protection [Auto]
Allows yous to enable/disable the southbridge overheat auto-protection function or
set the temperature over which the system shuts down.
Conguration options: [Auto] [70C] [80C] [Disabled]
OPT_TEMP2 Overheat Protection [Disabled]
If you monitor a device temperature using a thermal sensor cable connected to the
OPT_TEMP2 connector, you can use this item to set the temperature over which
the system shuts down or disable this function.
Conguration options: [Disabled] [50C] [60C] [70C] [80C] [90C]
OPT_TEMP1 Overheat Protection [Disabled]
If you monitor a device temperature using a thermal sensor cable connected to the
OPT_TEMP1 connector, you can use this item to set the temperature over which
the system shuts down or disable this function.
Conguration options: [Disabled] [50C] [60C] [70C] [80C] [90C]
CPU Fan and Chassis Fan
Select Screen
Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
CPU Fan Speed [4411RPM]
CPU Q-Fan Control [Disabled]
Chassis Fan 1 Speed [N/A]
Chassis Fan 2 Speed [N/A]
Chassis Fan 3 Speed [N/A]
Chassis Q-Fan Control [N/A]
Chassis Fan 4 Speed :N/A
CPU Fan Speed
BIOS SETUP UTILITY
Power
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
CPU Fan Speed [xxxxRPM] or [Ignored] / [N/A]
The onboard hardware monitor automatically detects and displays the CPU
fan speed in rotations per minute (RPM). If the fan is not connected to the
motherboard, the eld shows N/A.
CPU Q-Fan Control [Disabled]
Allows you to enable or disable the CPU Q-Fan controller.
Conguration options: [Disabled] [Enabled]
Chassis Fan 1/2/3 Speed [xxxxRPM] or [Ignored] / [N/A]
The onboard hardware monitor automatically detects and displays the
chassis fan speed in rotations per minute (RPM). If the fan is not connected
to the motherboard, the eld shows N/A.