EasyManua.ls Logo

Asus DELUXE A7N8X-E - Internal Connectors

Asus DELUXE A7N8X-E
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ASUS A7N8X-E Deluxe motherboard
2-19
13. USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB)
ports are available for connecting USB 2.0 devices.
14. PS/2 keyboard port. This purple connector is for a PS/2 keyboard.
2.7.2 Internal connectors
1. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)
This connector supports the provided UltraATA100 IDE hard disk ribbon
cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray
connector to the UltraATA100 slave device (hard disk drive) and the
black connector to the UltraATA100 master device.
1. Follow the hard disk drive documentation when setting the device
in master or slave mode.
2. Pin 20 on each IDE connector is removed to match the covered hole
on the UltraATA cable connector. This prevents incorrect orientation
when you connect the cables.
3. The hole near the blue connector on the UltraATA cable is intentional.
A7N8X-E
®
A7N8X-E IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE1
PIN 1
PRI_IDE1

Table of Contents

Related product manuals