2-38
Chapter 2: Hardware information
4. USB connectors (10-1 pin USB34; 10-1 pin USB78; 10-1 pin USB910)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
5. IEEE 1394a port connector (10-1 pin IE1394_1; 10-1 pin IE1394_2)
These connectors are for IEEE 1394a ports. Connect the IEEE 1394a
module cable to one of the connectors, then install the module to a slot
opening at the back of the system chassis.
You can connect the front panel USB cable to the ASUS Q-Connector (USB,
onboard if your chassis supports front panel USB ports.
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage
the motherboard!
You can connect the front panel 1394 cable to the ASUS Q-Connector (1394,
onboard if your chassis supports front panel 1394 ports.
To Next Page
Loading...
