2.4.3 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then
press <Enter> to display the sub-menu.
NorthBridge Conguration
Memory Conguration
Bank Interleaving [Auto]
Allows you to enable the bank memory interleaving.
Conguration options: [Disabled] [Auto]
Channel Interleaving [Disabled]
Allows you to enable the channel memory interleaving.
Conguration options: [Disabled] [Address bits 6] [Address bits 12]
[XOR of Address bits [20:16,6] ] [XOR of Address bits [20:16,9] ]
MemClk Tristate C3/ATLVID [Disabled]
Enables or disables the MemClk Tristate C3/ALTVID.
Conguration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Enables or disables the memory remapping around memory hole. Conguration
options: [Disabled] [Enabled]
DCT Unganged Mode [Auto]
Allows you to enable or disable Unganed mode.
Conguration options: [Auto] [Always]
Power Down Enable [Enabled]
Enables or disables the DDR power down mode.
Conguration options: [Disabled] [Enabled]
ECC Conguration
ECC Mode [Disabled]
Enables or disables the DRAM ECC that allows the hardware to report and correct
memory errors automatically. Conguration options: [Disabled] [Basic] [Good] [Super]
[Max] [User]
Alternate VID [Auto]
Allows you to set the alternate VID in low power states.
Conguration options: [1.150 V] to [0.800 V] with an increment of 0.025V
Internal Graphics
Primary Video Controller [GFX0-GPP-IGFX-PCI]
Display Device Priority, from high to low. Conguration options: [GFX0-GPP-IGFX-PCI] [GPP-
GFX0-IGFX-PCI] [PCI-GFX0-GPP-IGFX] [IGFX-GFX0-GPP-PCI]
UMAFrame Buffer Size [Auto]
Allows you to select the UMA Frame Buffer size. Conguration options: [Auto] [32MB]
[64MB] [128MB] [256MB] [512MB]
Surround View [Disabled]
If you set the PCI Express device as the primary display and enable this item, you may use
the internal graphics as the secondary display. Conguration options: [Disabled] [Enabled]
Frame Buffer Location [Above 4G]
Conguration options: [Below 4G] [Above 4G]